Full Automatic EPS Block continuous cutting machine is used for cutting polystyrene block. The EPS electric foam cutter use hot cutting wire to do block cut. It is important to place the cutting wire correctly. At first, the cutting wire should be placed strictly parallel with each side, if the cutting wire is not placed correctly, the cutting surface will not parallel, the tolerance will be bigger. There are the mark lines in the wire column for reference. Secondly, the tension of the wire is also important, if the tension is not enough, the surface will be rough, but if the tension is too bigger, the hot wires are easy to be broken during the block transferring. Normally the tension can be tested by fingers one by one, there is also the relevant tooling to test the tension. Thirdly, the electric current is also very important for different types of block, it must be set correctly. The current can be checked according to block surface status, if the surface color is a little black or there are some black lines on the surface, normally it is because the current is too big, but if the cutting surface is more rough, it maybe is because the current is too small. Normally the normal block needs the smaller current, but the F.R. blocks needs the bigger current.
|Precious Conveyor Belts Ensure Smooth Transferring Of The Blocks||Vibration Cutting Section|
|Continuous Cutting- Horizontal||Continuous Cutting- Vertical||Conveyor Racks After Fabrication And As Sembling|