Maintenance method of Eps Foam Cutter

- Nov 15, 2017 -

Eps foam cutter in use before and after the need for careful maintenance, so as to extend the service life of the Eps foam cutter, then how to maintain it? This article introduces this knowledge to you.

1. The waste material in the collection box should be cleaned regularly to prevent the waste from blocking the air outlet too much;

2. Clean the Eps foam cutter regularly, remove the sundries on the table, the retainer and the guide rail, and spray the lubricating oil on the guide rail;

3, every half a month to clean the chiller once, row the dirty water in the machine, and then replace the new pure water;

4, the indoor environment will have a certain impact on the life of the machine, especially wet and dusty environment. Wet environment is easy to make reflective lenses rusty, but also easy to cause circuit short circuit or laser discharge, sparking and other issues.

5. The mirror and the focus lens should be cleaned every 6-8 hours with a special cleaning solution, scrub with cotton swab or cotton swab dipped in cleaning liquid, from the focus of the mirror to the edge of the counter clockwise scrub, and should be careful to wear the lens;

EPS cutting machine with double vibration cutting sections.jpg


Related Industry Knowledge

Related Products

  • EPS Hot Wire Foam Cutter Can Be Used for Foam and Hotwire
  • High Efficient EPS Block Molder
  • Varialbe Types Of Eps Mould Making Machine
  • High Quality Eps Foam Coating Machine
  • Hot Sales EPS Block Making Machine By WINPLUS
  • The Valves Of WINPLUS Pre Expander Machine Are All From GEMU Germany